Making a Blowgun Mouthpiece using a Lathe / MyGunFreak`s Channel

Discussion in 'Off Topic' started by jt-1911, May 21, 2013.

  1. jt-1911

    jt-1911 Senior Member ProPlatinum

    317
    0
    0
  2. G_Y

    G_Y aiming the less

    383
    0
    0
    Good woodwork.

    The slingshot-blowgun in the videos later is probably not allowed in Germany when the compressed-air-shooted bullet has too much energy. Airguns have limitations, here.

    Rubberband saves energy with a thermal component, when getting colder a big part of the energy has gone.

    But it is a nice piece of work ;)
     

  3. Jazztuss

    Jazztuss Junior Member

    68
    0
    0
  4. jt-1911

    jt-1911 Senior Member ProPlatinum

    317
    0
    0
    You mean the rubber powered blowgun rifle? :) Thanks for the NIce replies
     
  5. That is really cool! Only one thing I would point out for power of your blowpipe is oak is a very porous wood. This makes it not a good choice for the tube section of a blowpipe do to the possibility of leaks, it is less of an issue for the mouthpiece I think but still something to be mindful of. That little bit of advice aside that was awesome!
     
  6. jt-1911

    jt-1911 Senior Member ProPlatinum

    317
    0
    0
    Thanks, I am going to try to make a few more some time :)